I have it connected to a manual 202 as found. Insulation is flaking off but phone works perfectly.
Usually I strap red or green to ground but nothing is connected to ground. I still tried but nothing.
I brought the ringer to every other post besides where the right side is connected ... Na Da!
What am I missing?....many thanks...Doug
Hi Doug
Have you done a resistance check on those coils?
Some of those wires don't look none too good.
Do you know when was the last time that subset did work?
Also, do you have a magneto you can bridge across the bells?
How about a laptop power supply? that could give you enough to tell if the bells are trying to work?
Or, maybe the cap is bad?
Just a suggestion...or 3 :)
Regards
Rod...No idea when it was last used, just got it in a lot of phones
The 202 works fine on the subset, subset just does not ring.
I was just hoping for someone to see if I missed on the wiring...thanks...Doug
Don't know about the ringer, but you have the 202 connected wrong. Move yellow from GND to L2-Y, green over one to GN, and red over one to R. Black wire from 202 not used.
David....that did the trick....subset rings perfectly!
Many thanks my friend....Doug