Mixing Old with New....

[Babybearjs]

well, I am plugging along.... enclosed are the pictures of some 1A1 units mounted on a new rack assembly... I bought the unit from Rosewill, had to only use the rails because of the spacing configuration. am finally at a point to where I'm getting ready to mount it to the wall... the unit weighs about 50 pounds and is going to be a challenge to hang! but, once done.... I'll have my 208 KTU's mounted and Operational! here are some pictures of the final frame work...

[Key2871]

Wow, looking good. Is the on a gate or hinge so you can service the back if needed?

[Babybearjs]

Unfortunately not. the unit once hung will be fixed to the wall... i'll have to loosen the 12 screws to remove it from the wall... the darn thing weights about 50#'s! once I hang it, it stays! though I can remove the individual units for servicing... I used the Vertical uprights to build this, so now, its going to hang horizontally. that is why I used the 25 pair cable on it... I don't want to have to pull this unit down once its up...