"The phone is a remarkably complex, simple device,
and very rarely ever needs repairs, once you fix them." - Dan/Panther

Main Menu


Started by Babybearjs, June 04, 2014, 12:59:34 PM

Previous topic - Next topic


OK, so now my system is working.... except for the 202b.... sort of.... when the line is picked up, the light works, when put on hold, the light flashes.... but when a call comes light, and the R relay only closes when a ring pulse is detected for the first few rings and then goes steady until the line is dropped... what wiring do I need to check to remedy this.... or is it because its connected to a VOIP ATA controller.... I had a rough time connecting the control leads (TO, LK, HA, C) because the cross reference gets confusing... it seems to be right now, but not sure...the schematics are hard to read at times because the terminals are almost the same numbers, etc.  I wish these papers were easier to read...