Author Topic: D1 wont behave  (Read 3460 times)

Offline poplar1

  • ***
  • Posts: 6255
  • 1051-AL
Re: D1 wont behave
« Reply #15 on: February 28, 2015, 05:21:16 PM »
Yes, just reverse the green and yellow handset cord leads on either end and it should work.
"C'est pas une restauration, c'est une rénovation."--François Martin.

Offline Steve

  • *
  • Posts: 446
Re: D1 wont behave
« Reply #16 on: February 28, 2015, 05:24:36 PM »
I reversed them and still pops. then tried with wire to W removed. niether made a difference.

I will take a photo of tha handset terminals and post it. maybe I'm missing something.
If you're a long way from home,
Can't sleep at night.
Grab your telephone,
Something just ain't right.

Offline Steve

  • *
  • Posts: 446
Re: D1 wont behave
« Reply #17 on: February 28, 2015, 05:28:48 PM »

 O.K.

here is how the handset is wired currently.





If you're a long way from home,
Can't sleep at night.
Grab your telephone,
Something just ain't right.

Offline poplar1

  • ***
  • Posts: 6255
  • 1051-AL
Re: D1 wont behave
« Reply #18 on: February 28, 2015, 05:34:35 PM »
In the photo, the terminals are left to right R (common), BK (transmitter), W (receiver). So all 3 wires are not going to the right place in the phone! I would start by putting the red wire on R inside the handset and on R of the dial. Then yellow to BK on both ends, and green to W in hs and W on dial.
"C'est pas une restauration, c'est une rénovation."--François Martin.

Offline Steve

  • *
  • Posts: 446
Re: D1 wont behave
« Reply #19 on: February 28, 2015, 06:04:18 PM »
In the photo, the terminals are left to right R (common), BK (transmitter), W (receiver). So all 3 wires are not going to the right place in the phone! I would start by putting the red wire on R inside the handset and on R of the dial. Then yellow to BK on both ends, and green to W in hs and W on dial.


Got it wired this way now. still pops with W connected and disconnected.

Wife needs me to run to the store, but I'll check back in later when I get back.

Thanks Guys for helping me out.
If you're a long way from home,
Can't sleep at night.
Grab your telephone,
Something just ain't right.

Offline Steve

  • *
  • Posts: 446
Re: D1 wont behave
« Reply #20 on: February 28, 2015, 09:48:02 PM »
In the photo, the terminals are left to right R (common), BK (transmitter), W (receiver). So all 3 wires are not going to the right place in the phone! I would start by putting the red wire on R inside the handset and on R of the dial. Then yellow to BK on both ends, and green to W in hs and W on dial.


 SUCCESS!

 NO MORE POPS!

wife was talking to me earlier and I missed one. thanks for your help.

now, I just need to get the ringer working.
If you're a long way from home,
Can't sleep at night.
Grab your telephone,
Something just ain't right.