Author Topic: Western Electric 1D2 with 32A board not sending ATCS Tones  (Read 130 times)

Offline phr34k5h0w

  • *
  • Posts: 153
Western Electric 1D2 with 32A board not sending ATCS Tones
« on: March 24, 2020, 07:26:31 PM »
So ive been playing around with coin trunks through asterisk on NPSTN, 

However I cannot get the darn 1D2 to send ATCS tones whatsoever.    However I can redbox the trunk just fine.  So its gotta be something in the phone itself. 

I have a 32A Board,  and 22B totalizer. 

I had to tie this shut on the totalizer to get the coins to go into the vault. 
See image below

Its always worked just fine as a regular phone on my system

Thanks again

Offline rcourtney

  • *
  • Posts: 30
Re: Western Electric 1D2 with 32A board not sending ATCS Tones
« Reply #1 on: March 26, 2020, 11:45:59 PM »
Carefully untwist the added wire. Check the continuity of the coil. It has hair thin copper wire that can easily be broken. 
All dip switches set to the left?  Under the 32A there are base rate jumpers or switches.  Set those to your base rate. Can't be zero.  At lease one must be set.
« Last Edit: March 30, 2020, 06:10:33 PM by rcourtney »