Author Topic: Installing an AECo mini-network into a WECo D1 Mount  (Read 10420 times)

Offline markosjal

  • ****
  • Posts: 425
Re: Installing an AECo mini-network into a WECo D1 Mount
« Reply #30 on: March 07, 2018, 07:14:14 PM »
I have updated this diagram to show the proper numers for those networks that do not have wires. Some have spade lug quick connects.

I have also added the spark supression capacitor/resistor module removed from a rotary styleline handset. It should work for dial and hookswitch contacts. This AE unit tucked nicely above the entry for the monting and handset cords, and gave me wires that were just about the right length. Of couyrse this was the best I could figure out and I can not say it is guaranteed to be accurate. It is working in a 202 with mini AE network.

Mark
« Last Edit: March 07, 2018, 07:41:32 PM by markosjal »
Phat Phantom's phreaking phone phettish

Offline kleenax

  • TelephoneCreations.com
  • Hero Member
  • *****
  • Posts: 638
  • Worlds Fair - 302
    • TelephoneCreations.com
Re: Installing an AECo mini-network into a WECo D1 Mount
« Reply #31 on: March 08, 2018, 09:47:13 PM »
I don't know if this will help, but I did this cross-reference diagram quite some time ago when I was using these little networks more. (.pdf attached)

I also wrote an article for TCI's SingingWires some time ago about mounting one of these into a B1 mount. Must have been around 2006 or so.
Ray Kotke
Recumbent Casting, LLC