Author Topic: Japanese OKI #4 Phone (Read 5904 times)

dsk · « **Reply #15 on:** January 09, 2014, 01:37:11 AM »

Just guessing, not based on real measuring.
If needed the F1 or an Antwerp transmitter may fit. You may have to adjust the contact springs.

The receiver are more like the typical German ones.

The resistor would still be worth to try, just put it wire terminals for the transmitter cord.

dsk

wds · « **Reply #16 on:** January 12, 2014, 10:28:43 AM »

So OKI made the phone, but Toshiba made the handset? Any idea what the relationship was between Toshiba and OKI?

rdelius · « **Reply #17 on:** January 12, 2014, 04:13:45 PM »

These were all built to the same standards by many mfg companies.They might have molded it for another company.It might have been replaced also.I have seen AE handsets with the GE logo molded inside for a US example

If your visit to the Classic Rotary Phones Forum was enjoyable or helpful, you may tell us by making a small donation. The donation can be made safely via PayPal and will help to off-set the costs of the Forum operation. Thank you!