Author Topic: Kellogg 9745 Spacesaver Wiring Diagram Needed (Read 1644 times)

LarryInMichigan · « **on:** February 02, 2012, 07:21:23 PM »

I won this: ebay link a few days ago, and it arrived today. It is apparently a Kellogg 9745. I came with a badly battered AE type 81 handset connected to the phone with a two-conductor power cord. Inside the phone is an inductor coil, but there is no condenser. There was part of some sort of buzzer attached to the inside of the housing, so I am guessing that there used to be a condenser there. Interestingly, the phone has an FTR dial. The phone is quite heavy.

In the 1941 Kellogg catalog, there are versions of this phone without a dial.

I do not see any wiring diagrams on the TCI site for this model. Can someone direct me to a diagram?

Thank you

Larry

LarryInMichigan · « **Reply #1 on:** February 02, 2012, 09:13:21 PM »

The inductor coil is marked "106A", the same as the coil in the CB version of the Kellogg 925. The hook switch also has the same types of contacts as the 925's, so with the addition of a couple of 1µF capacitors, it should be possible to wire this phone just like a 925. It will take some effort though. Someone has rearranged some of the soldered wires, and there are currently only two wires running to the dial.

The dial is apparently from military stock. It has "MFP 8-50" along with various numbers stamped on the back in vermillion.

Larry

If your visit to the Classic Rotary Phones Forum was enjoyable or helpful, you may tell us by making a small donation. The donation can be made safely via PayPal and will help to off-set the costs of the Forum operation. Thank you!