Protel Ascension

Bob S · April 12, 2020, 06:03:41 AM

Hi I have a Protel Ascension that works with the original 8000 REV D Module Picture 3. I would like to keep this one programed the way it is. While I am trying to program a second 8000 Rev C. Does the rev D or C make a difference. I have some pictures of the screens where I am adding the message picture 1 and 2 . Any help appreciated. If I can help anybody else with getting this far please ask and I will try to help

Payphone411 · May 17, 2020, 05:51:00 PM

The Options & Registers display options shown is for LCD screens only. I will message you what location you need to update for your display.

Bob S · May 17, 2020, 06:45:28 PM

Thank You Looking forward to hear from you.

Bob S · May 20, 2020, 06:31:35 AM

Figured it out I believe this is it. Tried this but did not work still working on it.

Bob S · May 29, 2020, 06:22:41 AM

Any Ideas still trying. If I can get the message figured out. Would be Great.

Payphone411 · May 31, 2020, 10:41:38 AM

Check Your Private messages

Bob S · May 31, 2020, 10:51:49 AM

Ok

ericthivierge · July 19, 2022, 08:23:55 PM

Good evening, Did you manage to schedule your messages? I have the same problem with my protel ascension... Thank you

ericthivierge · July 19, 2022, 08:31:27 PM

Quote from: Bob S on May 20, 2020, 06:31:35 AMFigured it out I believe this is it. Tried this but did not work still working on it.

Does it work now? I have the same problem, impossible to change the messages.

Payphone411 · December 11, 2022, 12:18:03 PM

At the main screen you select

2. Call Costing Records Menu - Select your Costing Records you want to apply the messages to.
Then Press 5. Edit Routes and at this screen press F7, Change Messages

Under Select-A-Carrier 1 thru 6 will display on the top.
Under Card Router 7-10 will display on the bottom. MAX 20 characters

Ill get some photos up if that helps. Let me know.

MADhouseTelephone · September 22, 2024, 11:52:39 AM

I recently acquired one of these Cincinnati Bell protel Ascension phones. Can somebody tell me where the power wiring connects up to the circuit board?

going2west · September 29, 2024, 04:08:51 AM

I have protel 7800 that have 7000s board and lcd screen. There are no message on a screen. Apparently some of the Ascension phones have same 7000s board and power module(right on terminal block) to supply 5V to JS connector of 7000S board. Connector is 3pins connector and pin3 is a negative for 5V. How to connect positive? Does anybody have a picture of both sides of that board?

News:

Protel Ascension